This impression silicone is perfectly suitable for the production of detailed silicone moulds. All objects can be perfectly moulded with this translucent silicone. Due to the very good flow properties, highly filigree, clean moulds with the highest moulding accuracy can be achieved. Thanks to the translucency, the processing can be easily controlled. It can also be individually coloured with our silicone colours.
TFC Baseline 100 impression silicone is environmentally friendly, odourless and non-toxic, and is also temperature-resistant from -60°C to +250° C for short periods. It is further characterised by excellent resistance to weather, ageing, temperature and acid and can therefore be used in many areas.
Processing instructions:
Shake up both components separately before mixing. Take equal parts by weight of components A+B, mix carefully, avoid air mixing. Pour the homogeneous mixture evenly into the prepared mould with a thin pouring stream.
Mixing time at 23 degrees Celsius: approx. 1 minute Processing time at 23 degrees Celsius: approx. 12 minutes Curing time at 23 degrees Celsius: approx. 140 minutes
Product type: Silicone rubber Hardness Shore: A35 Colour: translucent Viscosity: 7000 mPas Mixing ratio: 1:1 Mixing time at 23 degrees Celsius:1 min Processing time at 23 degrees Celsius: 4 min Curing time at 23 degrees Celsius: 60 min Elongation at break (in %): 450 Tear strength: 8.0 N/mm² Dimensional change in % after 24h: 0.1
Group
Mould
State
new
Not a toy! Not suitable for children under the age of 14!
