This liquid solvent allows modellers to eliminate those annoying traces of cyanoacrylate adhesive that remain on the surface after building.
Debonder can be used on a wide range of surfaces including plastic, resin, and photo etch. Simply apply using a brush or a pipette onto the glue and let it act for about 45 seconds. Then clean the surface with a cloth. If necessary, these steps can be repeated until the cyanoacrylate is completely removed. Do not use this product over painted surfaces.
Always keep this container out of reach of children and tightly sealed, use the solvent with protective equipment in an adequately ventilated area safe from high temperatures. Keep out of reach of children and avoid contact with skin and eyes. If contact occurs, thoroughly rinse immediately with water.
Debonder can be used on a wide range of surfaces including plastic, resin, and photo etch. Simply apply using a brush or a pipette onto the glue and let it act for about 45 seconds. Then clean the surface with a cloth. If necessary, these steps can be repeated until the cyanoacrylate is completely removed. Do not use this product over painted surfaces.
Always keep this container out of reach of children and tightly sealed, use the solvent with protective equipment in an adequately ventilated area safe from high temperatures. Keep out of reach of children and avoid contact with skin and eyes. If contact occurs, thoroughly rinse immediately with water.
- State
- New
Warning, harmful to health!
Not a toy! Not suitable for children under the age of 14!
Ammo by MIG Jimenez, S.L.
Calle Zarapuz 3
31200 Estella (Navarra)
Spanien
E-Mail: [email protected]
Website: www.migjimenez.com
Calle Zarapuz 3
31200 Estella (Navarra)
Spanien
E-Mail: [email protected]
Website: www.migjimenez.com
Copyright © 2026 Berliner Zinnfiguren & Preussisches Buecherkabinett
Berliner Zinnfiguren, Knesebeckstr. 88, 10623 Berlin, Germany
Phone 0049 (30) 315 700 0