Phone: 0049 (0)30 315 700 0
- You are here:
- Paints & Tools
- Tools
- Engrave, emboss, punch
Description
Engraving pin with a 0.7mm blade width made of tungsten carbide.
Engraving pin with a 0.7 mm blade width made of tungsten carbide (the so-called Widia), which makes it highly resistant to abrasion and significantly higher hardness than ordinary steel. The tool is perfect for precise engraving work on plastic models, such as creating delicate dividing lines on airframes or airframes. It is recommended to use the presented engraving spindle with dedicated handles, such as reference 336/BD33.
Sharp parallel cutting edge can easily engrave neat line grooves, and the debris is curled up and pulled out by the chisel. Side appereance of the chisel head is smooth and flawless. Each chisel is elaborately grinded and polished by craftsmen.
The product adopts stainless steel hand grip with polished surface, and the chisel is made of HRA=90 high quality tungsten (cemented carbide), which is elaborately polished. The two parts are connected by brazing. Important note: as the size is 0.15mm, be careful to control the angle while using it and avoid being hit against.
Overall Length of the product: 94mm x 4.8mm.
Length of blade: 25mm.
Engraving pin with a 0.7 mm blade width made of tungsten carbide (the so-called Widia), which makes it highly resistant to abrasion and significantly higher hardness than ordinary steel. The tool is perfect for precise engraving work on plastic models, such as creating delicate dividing lines on airframes or airframes. It is recommended to use the presented engraving spindle with dedicated handles, such as reference 336/BD33.
Sharp parallel cutting edge can easily engrave neat line grooves, and the debris is curled up and pulled out by the chisel. Side appereance of the chisel head is smooth and flawless. Each chisel is elaborately grinded and polished by craftsmen.
The product adopts stainless steel hand grip with polished surface, and the chisel is made of HRA=90 high quality tungsten (cemented carbide), which is elaborately polished. The two parts are connected by brazing. Important note: as the size is 0.15mm, be careful to control the angle while using it and avoid being hit against.
Overall Length of the product: 94mm x 4.8mm.
Length of blade: 25mm.
- Group
- Tools
Not a toy! Not suitable for children under the age of 14!
We also recommend this article
The following articles may also interest you
Take a look at our similar products.Copyright © 2024 Berliner Zinnfiguren & Preussisches Buecherkabinett
Berliner Zinnfiguren, Knesebeckstr. 88, 10623 Berlin, Germany
Phone 0049 (30) 315 700 0