Phone: 0049 (0)30 315 700 0
- You are here:
- Paints & Tools
- Helpers
- Decal Accessories
Description
Mark Fit is a special solvent designed to soften your model decals which will allow you to apply them onto difficult to apply areas such as bumpy and curved surfaces, providing an improved finish to your scale model. The 40ml bottle contains a convenient brush for easy application.
How to Use
- Apply Mark Fit solvent to area where decal is to be positioned.
- Place decal onto the area.
- Slide decal into correct position by a wet finger.
- Use a soft cloth or cotton swab to remove excess water and any air bubbles.
- Apply Mark Fit over the decal again, and then use a soft cloth or cotton swab to conform it to the model's surface.
- Do not touch until decal dries completely.
How to Use
- Apply Mark Fit solvent to area where decal is to be positioned.
- Place decal onto the area.
- Slide decal into correct position by a wet finger.
- Use a soft cloth or cotton swab to remove excess water and any air bubbles.
- Apply Mark Fit over the decal again, and then use a soft cloth or cotton swab to conform it to the model's surface.
- Do not touch until decal dries completely.
We also recommend this article
The following articles may also interest you
Take a look at our similar products.Copyright © 2024 Berliner Zinnfiguren & Preussisches Buecherkabinett
Berliner Zinnfiguren, Knesebeckstr. 88, 10623 Berlin, Germany
Phone 0049 (30) 315 700 0