Addition-curing 2-component silicone rubber that vulcanises at room temperature (RTV).
The silicone is supplied in high-quality plastic squeeze bottles with a dosing cap. This makes dispensing very easy and clean. Exact dosing is effortless, as you would expect from comparable food packaging, for example and represents a significant improvement on the usual tinplate cans or wide-neck bottles.
Properties and application: - easy processing - easy mixing of the components 1:1 by weight - very good flowability, mixture is easy to pour - cross-linking into resistant, elastic material without reaction heat - Temperature resistant up to 150 °C for short periods - High tear resistance and high flexibility - Very high level of detail in reproduction - excellent non-stick effect for easy release of the models - Use e.g. in dental technology for duplicating and in model and mould making.
Further product information: Colour: green (component A) and white (component B) Mixture: 1:1 by weight Specific weight: 1.1 Viscosity 4000 ± 300 cP Mixing time at 23 degrees Celsius 1 minute Working time (pot life) at 23 degrees Celsius 6-8 minutes Curing time at 23 degrees Celsius 40 minutes Shore A hardness after 24 hours 18-20 Breaking strength 4.0 ± 0.2 N/mm² Elongation at break 380 ± 20 Tear strength 20 ± 1 N/mm Detail accuracy: 2 micron Dimensional change after 24 hours 0.02 %
TFC silicone rubber type 1 is very well suited for the production of demanding, elastic and hard-wearing moulds with pronounced undercuts.
TFC Silicone Rubber Type 1 can be used to produce single or multi-part moulds, for moulding original models made of wood, glass, metal, plastic, wax, ceramic casting compounds.
They can be used in the moulds produced with all water-soluble casting materials such as Relief casting compounds such as Stewalin, Plastalin Super, Keraflott or plaster, Keramin, Alabit, modelling and modelling plaster, casting clay, cement, concrete, etc. in the moulds produced.
Soap moulding compounds (soap glycerine) for making your own soap or wax for making candles are also possible without any problems, as is moulding with casting resins (resin). You should pre-treat the mould with a release agent before pouring, as casting resins can cause the mould to become brittle after repeated casting.
The silicone has not been tested for skin and mucous membrane compatibility or for use in conjunction with food. If you are looking for silicones that you would like to use in conjunction with food or body moulding, TFC Alginate Moulding Compound Blue No. 412/TFC1062.
State
New
Not a toy! Not suitable for children under the age of 14!
