Phone: 0049 (0)30 315 700 0
- You are here:
- Paints & Tools
- Tools
- Polishing, Grinding
The sandpaper holder makes it possible to clamp sandpaper in the desired grit size so that a perfectly flat surface is created for working on model components.
All you have to do is cut the sandpaper into strips of 14x2 cm. No tools or glue are needed for clamping. Particularly large surfaces can be perfectly machined without the unevenness caused by normal sanding by hand.
It is best to write down the chosen grit with a pen.
Dimensions:
Width (mm): 20
Length (mm): 53
Height (mm): 1
Scope of delivery: 2 holders
- Due to the production in the 3D printer, there may be irregularities on the surface.
- Two holders are supplied, any other material shown is for illustration purposes.
All you have to do is cut the sandpaper into strips of 14x2 cm. No tools or glue are needed for clamping. Particularly large surfaces can be perfectly machined without the unevenness caused by normal sanding by hand.
It is best to write down the chosen grit with a pen.
Dimensions:
Width (mm): 20
Length (mm): 53
Height (mm): 1
Scope of delivery: 2 holders
- Due to the production in the 3D printer, there may be irregularities on the surface.
- Two holders are supplied, any other material shown is for illustration purposes.
- State
- New
Not a toy! Not suitable for children under the age of 14!
The following articles may also interest you
Take a look at our similar products.Copyright © 2026 Berliner Zinnfiguren & Preussisches Buecherkabinett
Berliner Zinnfiguren, Knesebeckstr. 88, 10623 Berlin, Germany
Phone 0049 (30) 315 700 0