Phone: 0049 (0)30 315 700 0
- You are here:
- Paints & Tools
- Tools
- Fixtures
This aid was specially developed for painting figures / busts. The figures are pinned with the help of a sturdy steel wire (2 mm, 2 x enclosed).
For this purpose, a 2 mm hole is drilled into the leg of the figure / underside of the bust. Now insert the steel pin and glue it in place. After the glue has dried, the figure is clamped in the handle. This makes it much easier to handle the figure during the painting process.
The handle lies well in the hand due to the ribbing and the figure can be turned easily. After finishing the work, the handle can be put into the holder and the figure can wait for the next work step or dry, for example. Thanks to the large footprint, the holder does not tip over.
Ideal for figures from 28 mm or 54 mm size.
Length of the handle approx. 11 cm, diameter approx. 1 cm. Diameter of the hole 2 mm.
For this purpose, a 2 mm hole is drilled into the leg of the figure / underside of the bust. Now insert the steel pin and glue it in place. After the glue has dried, the figure is clamped in the handle. This makes it much easier to handle the figure during the painting process.
The handle lies well in the hand due to the ribbing and the figure can be turned easily. After finishing the work, the handle can be put into the holder and the figure can wait for the next work step or dry, for example. Thanks to the large footprint, the holder does not tip over.
Ideal for figures from 28 mm or 54 mm size.
Length of the handle approx. 11 cm, diameter approx. 1 cm. Diameter of the hole 2 mm.
- Group
- Tools
- State
- New
Not a toy! Not suitable for children under the age of 14!
We also recommend this article
The following articles may also interest you
Take a look at our similar products.Copyright © 2026 Berliner Zinnfiguren & Preussisches Buecherkabinett
Berliner Zinnfiguren, Knesebeckstr. 88, 10623 Berlin, Germany
Phone 0049 (30) 315 700 0